Recursive Workflow Keeps Falling Short

muellerme · 2024-11-04T05:37:54.255Z

I have a recursive workflow where every time a basket number lands on a basket position of 1, it gets plus one pass. the basket positions are shuffling plus one position till they get to position 1 six times (total passes). However my recursive workflow just falls short, what only when condition could I use for the recursive workflow to stop when all values hit 6 instead of falling one short like in this example. (6 is a value of the variable “Total Passes”, which is determined by a dropdown input).

41513×343 21.4 KB

Figure 1. Data Table.

1574×391 15.3 KB

Figure 2. Recursive workflow using is not.

The filter is counting the amount of entries that equals 6.

2736×409 21.1 KB

Figure 3. Making sure the filter counts passes to the variable of total passes, recursive workflow keeps running until they hit 6.

31038×355 12.7 KB

Figure 4. The recursive workflow just running short and keeps leaving one entry minus one pass away from its total pass.

I believe it is the “is not” statement in the only when condition of the recursive workflow, but not sure what to substitute instead.

boston85719 · 2024-11-04T15:08:31.404Z

What are you trying to achieve? Are you running one of these entries at a time or are you running all items in DB?

What is the point of Passes and Total Passes?

Also, there is likely an issue based on the use of the Search for…you use it in the parameter and the condition and the filter in the condition…most likely there is a much more WU efficient way to handle this.

If you provide the overall outcome you are looking to achieve and the use case of it, that may be easier for somebody to provide you guidance on how to set this up properly.

system · 2025-01-13T05:38:30.711Z

This topic was automatically closed after 69 days. New replies are no longer allowed.